Easter potato stamp art

Potato stamp art is so much fun! Today we’re sharing how to make simple potato stamp bunnies and chicks for Easter or Spring.

You can create wall art with your potato stamping, turn them into Easter cards or even handmade gift wrap. So cute, and easy enough for all age groups too.

*This Easter art project was first published in 2021 and has been updated and reshared for today’s audience

You might also like these 10 bunny craft ideas

Years ago, when my girls were small, we created potato stamp chicks for Easter.

I decided to revisit the project so I could make a tutorial video and add a bunny version of the stamping art. The bunnies turned out so sweet with a little thumbprint tail. If you wanted to you could switch the thumbprint for a glued-on pom pom instead.

We’ve used baby potatoes to make these bunnies and chicks, but they would work just as well with large potatoes too.

Let’s get started …

How to make Easter potato stamp art

You will need:

small washed potatoes
Sharp knife and cutting board
card stock paper to print on
kitchen sponge
acrylic paint
sharpie markers

How to:

Chop a potato in half vertically. With one half trim a small piece from the top, this becomes the head. With the other, cut it in half again vertically to make two ears. Trim a small piece from the end of each ear. The body is simply another potato cut in half.

The chick stamp is one potato cut in half (horizontally or vertically, it doesn’t matter), then one half cut in half again to make the wings.

Cut a kitchen sponge in half horizontally to make two rectangular pieces. These become your ‘ink pads’. Place them in a plastic container or an egg carton lid. Squirt paint directly onto them and squish and rub it in a bit. We’ve used white for the bunny and a warm yellow for the chick.

Get your paper ready. If you’re using white paint for your bunny you’ll need a coloured sheet of paper to print on. You can fold it on half so your printing becomes a card or just print on a full sheet to make wall art.

For the bunny, start by printing the head shape with the flattened part at the top. Then print on some ears above the head and a body at a slight angle underneath it. Use a thumbprint to make the tail. Allow to dry.

Here is a card version with two bunnies printed.

To make the chick, print the circle part for the body and then print the wings on. You can alternate them on your chicks to point up or down. Allow to dry.